According to reports, the "Code for the Recycling of Vehicle Power Battery Recycling" will be officially implemented from December 1, 2017. This is the first national standard for the recycling of power batteries proposed by the Ministry of Industry and Information Technology, clearly indicating the recycling and dismantling enterprises. It should have relevant qualifications to further ensure the safety, environmental protection and efficient recycling of power batteries. A Jaw Crusher is one of the main types of primary crushers in a mine or ore processing plant. The size of a jaw crusher is designated by the rectangular or square opening at the top of the jaws (feed opening). Primary jaw crushers are typically of the square opening design, and secondary jaw crushers are of the rectangular opening design. However, there are many exceptions to this general rule. Jaw Crusher,Mini Jaw Crusher,Portable Jaw Crusher,Mobile Primary Jaw Crusher Shenyang Sanland Mining Equipment Manufacture Co., Ltd. , https://www.sanlandcrusher.com
From February 1st, 2018, the new national standard for three power batteries, such as the “Recovery of Residual Energy for Vehicle Power Batteryâ€, will also be officially implemented. With the establishment of a relatively complete national standard system, the disordered state of power battery recycling and ladder utilization is expected to change.
The industry believes that domestic power batteries will enter the peak of scrapping around 2020, with a total scrapped amount of 120,000-17,000 tons, and the actual dismantling and recycling in 2016 is less than 10,000 tons. Due to improper treatment of the positive electrode material and electrolyte in the power battery, the environment is greatly polluted. At the same time, China must use recycling to alleviate the serious external dependence on scarce metals such as cobalt. Therefore, power battery recycling will become the key to the development of new energy vehicles in China, and policy support is expected to increase.
A Jaw Crusher reduces large size rocks or ore by placing the rock into compression. A fixed jaw, mounted in a "V" alignment is the stationary breaking surface, while the movable jaw exerts force on the rock by forcing it against the stationary plate. The space at the bottom of the "V" aligned jaw plates is the crusher product size gap, or the size of the crushed product from the jaw crusher. The rock remains in the jaws until it is small enough to pass through the gap at the bottom of the jaws.